Error Codes - Dometic SW180 Instructions D'installation Et De Fonctionnement

CLEANING
Before cleaning, always switch off the wine
cabinet and pull out the plug!
Clean the wine cellar regularly. Only use a mild
detergent when cleaning the cabinet inside. Do not
use any abrasive or strong scented substances. Use
a smooth cloth or sponge. Remember to clean the
drain, making sure it is not blocked by something.
If the wine cellar fails to work, check the following points before calling for service:
• Is the wine cellar switched on?
• Is the plug properly inserted in its socket?
• Are the controls set correctly?
• Has the power been cut off?
If the cause of failure is not to be found among the points listed above, contact an authorised service
technician.

ERROR COdES

If an error code (E1, E2, E or E) is displayed, please contact an authorised service technician.
ERROR COdE dESCRIPTION
• E1
Evaporator sensor failure. Faulty sensor or short circuit.
• E2
Air temperature sensor failure (white wine compartment). Faulty sensor or short circuit.
• E3
Air temperature sensor failure (red wine compartment). Faulty sensor or short circuit.
• E4
Display communication error. Faulty electric control unit or short circuit.
MAINTENANCE
TROUBLESHOOTING
- 20 -
If the cabinet is not to be used for more than 8
hours, the doors should be left open to allow airing.
To make the cooling system work at its optimum
it is necessary from time to time to clean the wire
grid covering the condenser and the compressor
at the back of the cabinet by means of a brush or
vacuum cleaner.