Yamaha DPX-1300 Mode D'emploi page 63

Problem
Remote control does The batteries are exhausted.
not work correctly.
The remote control sensor is not set
correctly.
There is a fluorescent lamp near the
remote control sensor being used.
The remote control code switch is
incorrectly set.
COVER warning The filter cover is not correctly attached.
indicator lights up.
The lamp cover is not correctly attached.
LAMP warning Lamp running time has exceeded 2000
indicator lights up or hours.
blinks.
The lamp has burned out.
TEMP warning indicator The temperature inside the DPX-1300 is
lights up. extremely high.
FAN warning indicator The fan is broken.
lights up.
• This unit uses a DMD TM chip for the picture display. Their highly accurate technology makes it possible to keep more than 99.99%
of effective pixels, however, unexpectedly it can produce less than 0.01% of ineffective pixels. In such a case, missing or flashing
of a few pixels can be found on the screen. These are characteristics of DMD
Cause Remedy
Replace both batteries with new ones.
Set correctly.
Press the MENU button to display the menu
and select [Setup]
Sensor].
Turn off the remote control sensor near the
fluorecent lamp, and use the other remote
sensor.
Set the remote control code switch to the
same ID number as the setting on the
"REMOTE CONTROL ID" in the setting menu.
Tightly attach the filter cover.
Tightly attach the lamp cover.
Replace the lamp with a new one.
Replace the lamp with a new one.
Check that the ventilation slots are not
covered.
Contact the store where the DPX-1300 was
purchased.
TM , not mechanical problems.
Troubleshooting
[Remote Control
11
61