Yamaha DPX-1300 Mode D'emploi page 23

<Using the INPUT button to select a signal>
Remote cotrol Main unit
+ button
AUTO
V. POS ZOOM FOCUS
IRIS SETTING PATT
ESCAPE
ESCAPE MENU
PATTERN
button
ASPECT
ASPECT INPUT
RESET HIDE
STILL LIGHT
INPUT
INPUT button
S VIDEO A HDMI
VIDEO B DVI
D4
MEMORY
1 2 3
4 5 6
Cursor button
1. Press the INPUT button.
The input signal selection menu appears on
the display.
STANDBY/ON
MENU
SETTING
INPUT
LAMP COVER TEMP FAN
2. Use the h or g buttons to select
an input signal, then press the
button.
Warning
• You can select [Component], [RGB PC], or [RGB TV] for INPUT A and INPUT B, or
[Auto], [Component], or [RGB TV] for HDMI, from the submenu. If you do not select a
setting, the unit continues to use the setting from the last signal it received. To
change this setting, carry out the following procedure.
3. Press the + button to open the
submenu.
4. Select an appropriate setting
from [Component], [RGB PC], or
[RGB TV] and press the
to confirm the setting.
Memo
• If you set your laptop or notebook computer to display on its built-in display and on
an external monitor simultaneously, the main unit may not project the image
correctly. In this case, set your computer to display on the external monitor only.
Refer to your computer's operating instructions for further details.
Selecting an input signal
Input signal
VIDEO
S VIDEO
INPUT A
INPUT B
HDMI
DVI
D4
Input signal
VIDEO
S VIDEO
INPUT A
INPUT B
HDMI
DVI
D4
Input signal
VIDEO
S VIDEO
INPUT A
INPUT B
HDMI
DVI
D4
The mark to the right of the input signal
name indicates that there is a submenu
available for selection.
Input signal
VIDEO
button
S VIDEO
INPUT A
INPUT B
HDMI
DVI
D4
8
Component
RGB PC
RGB TV
21