Installing/Removing Two-Piece Suction Pipe; Installing/Removing The Collection Bag; Attaching The Neck Strap; Fill With Fuel - Grizzly BLSB 3030 Traduction De La Notice D'utilisation Originale

GB
Installing/removing two-piece
suction pipe
1. Fit the two suction pipes
(23a+b) together.
2. Attach the two pipe pieces with
the supplied bolt and nut (33).
For security reason the two pipe
pieces cannot be taken apart later.
3. Loosen the fixing bolt (6) of the
intake cover (7) and open the
intake cover.
4. To install the upper suction pipe
(23a) in the engine housing (5),
position the plastic hook (22)
at the spring hinge (34) of the
intake cover (7).
5. Slide the two-piece suction pipe
(23) into the intake opening (8)
and screw fasten it with the en-
closed fixing screws (35).
As a safety precaution you can
only turn on the device if both pipe
parts have been correctly mounted
on the engine housing.
6. Remove the suction pipe (23) in
reverse order.
Installing/removing the
collection bag
In suction mode the device can
only be operated with the collec-
tion bag installed.
1. Attach the collection bag (30)
to the intake pipe (29) using the
Velcro strip.
2. If necessary, remove the blower
pipe (25) (see „Installing/remov-
ing blower pipe and blower at-
96
tachment").
3. Mount the intake pipe (29) of
the collection bag (30) at the
discharge chute (10) on the
engine housing (5) as described
under „Installing/removing blow-
er pipe and blower attachment".

Attaching the neck strap

Always wear a neck strap when
operating the device. Always turn
off the device, before removing the
neck strap. Accident hazard.
Attach the snap hook of the neck
strap (28) to the fixing lugs (1a+b)
on the engine housing (5).

Fill with Fuel

Always ensure good ventilation
when handling fuel.
Do not smoke when refuelling and
keep away from any heat sources.
Never refuel with the motor run-
ning or hot.
Open the filler cap carefully, so any
excess pressure that is present
can escape slowly.
Do not start the equipment near
the filling location.
Use suitable and authorised con-
tainers for storing the fuel.
There is a risk of fire or explosion
in case of non-observance.
Only use the fuel mix recommend-
ed in the instructions. This must
not be older than 3 months. In
case of non-observance, the motor
may be damaged and the guaran-
tee will be invalidated.