Parking Brake Release - Upright X Série Guide De L'opérateur

P B
ARKING RAKE
Perform the following only when the machine will
not operate under its own power and it is necessary
to move the machine or when winching onto a
trailer to transport.
NOTE:
X32N models have two identical brake adjustment
nuts located on both sides of the ladder. The X20N,
X20W, and X26N have only one.
The Brake Adjustment/Release Nut(s) is/are
located at the rear of the machine to the right and/or
left of the ladder.
1. To release the brakes turn the nut(s) counter-
clockwise until the brakes disengage the tires.
2. The machine will now roll when pushed or
pulled.
3. To re-engage the brakes, turn the nut(s) clock-
wise until the brakes have fully engaged the
tires. Verify that the brakes have fully engaged
the rear tires before operating the machine by
testing their ability to hold the machine on a
22% grade (X32N 20 %).
Never tow faster than 0,3 m/sec. (1 ft./sec.)
Never operate the work platform with the parking brakes released. Serious
injury or damage could result.
10
R
ELEASE
W A R N I N G
!

Parking Brake Release

REAR
X20N X20W X26N
Parking Brake Release
Figure 6: Parking Brake Release
!
REAR
X32N
X-Series Work Platform