Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
E
LEVATING THE
1. Select a firm, level surface.
2. Turn the Lift/Drive Switch to LIFT.
3. Engage the Interlock Switch and push the Control Handle forward.
4. If the machine is not level, the tilt alarm will sound and the machine will not lift or drive. If the tilt alarm
sounds, the platform must be lowered and the machine moved to a firm, level surface before
attempting to re-elevate the platform.
T
W
RAVEL WITH
NOTE:
The machine will travel at reduced speed when the platform is elevated.
1. Check that the route is clear of obstacles (persons, obstructions, holes, drop-offs, bumps, and debris), is
level, and capable of supporting the wheel loads.
2. Check clearances above, below, and to the sides of the platform.
3. Turn the Lift/Drive Switch to DRIVE.
4. Engage the Interlock Switch and move the Control Handle to FORWARD or REVERSE to travel in the
desired direction. The speed of the machine will vary depending on how far from center the Control Handle
is moved.
5. If the machine is not level, the tilt alarm will sound and the machine will not lift or drive. If the tilt alarm
sounds, the platform must be lowered and the machine moved to a firm, level surface before
attempting to re-elevate the platform.
L
OWERING THE
1. Turn the Lift/Drive Switch to LIFT.
2. Engage the Interlock Switch and pull back on the Control Handle to lower the platform.
3. The platform will stop when it reaches the PPE cut out height. To lower the platform fully, depress the green
PPE override button.
6
P
LATFORM
P
E
ORK
LATFORM
LEVATED
P
LATFORM
X-Series Work Platform
Publicité
Table des Matières
