Safety Rules - Upright X Série Guide De L'opérateur

English Language Section English Language Section English Language Section English Language Section
Electrocution Hazard
THIS MACHINE IS
NOT INSULATED
USE OF THE AERIAL WORK PLATFORM: This aerial work platform is intended to lift persons and their tools as well as the mate-
rial used for the job. It is designed for repair and assembly jobs and assignments at overhead workplaces (ceilings, cranes, roof
structures, buildings, etc.). All other uses of the aerial work platform are prohibited!
THIS AERIAL WORK PLATFORM IS NOT INSULATED! For this reason it is imperative to keep a safe distance from live parts of
electrical equipment!
Exceeding the specified permissible maximum load on the platform is prohibited!
X20N = 340 kg (750 lbs.) including 2 persons
X26N = 453 kg (1000 lbs.) including 3 persons X32N = 318 kg (700 lbs.) including 3 persons
The use and operation of the aerial work platform as a lifting tool or a crane (lifting of loads from below upwards or from up high on
down) is prohibited!
NEVER exceed 400 N (90 lbs.) of side force.
DISTRIBUTE all platform loads evenly on the platform.
NEVER operate the machine without first surveying the work area for surface hazards such as holes, drop-offs, bumps, curbs, or
debris; and avoiding them.
OPERATE the machine only on surfaces capable of supporting wheel loads.
NEVER operate the machine when wind speeds exceed 45 km/h (28 mph) (12,5 m/sec.= Beaufort scale 6).
IN CASE OF EMERGENCY push EMERGENCY STOP button to deactivate all powered functions.
Climbing up the railing of the platform, standing on or stepping from the platform onto buildings, steel or prefab concrete structures,
etc., is prohibited!
Dismantling the swing gate or other railing components is prohibited! Always make certain that the swing gate is closed and
securely locked!
It is prohibited to keep the swing gate in an open position (held open with tie-straps) when the platform is raised!
To extend the height or the range by placing of ladders, scaffolds or similar devices on the platform is prohibited!
NEVER perform service on the machine while theplatform is elevated without blocking the elevating assembly.
INSPECT the machine thoroughly for cracked welds, loose or missing hardware, hydraulic leaks, damaged cables or hoses, loose
wire connections and wheel bolts before using.
VERIFY that all labels are in place and legible before using.
NEVER use a machine that is damaged, not functioning properly, or has damaged or missing labels.
IF ALARM SOUNDS while the platform is elevated, STOP , carefully lower the platform. Move the machine to a firm, level surface.
To bypass any safety equipment is prohibited and presents a danger for the persons on the aerial work platform and in its working
range.
NEVER charge batteries near sparks or open flame. Charging batteries emit explosive hydrogen gas.
Modifications to the aerial work platform are prohibited or permissible only at the approval of UpRight.
AFTER USE, secure the work platform from unauthorized use by turning both keyswitches off and removing key.

Safety Rules

Tip Over Hazard
NEVER elevate the platform
or drive the machine with
platform elevated unless on
firm, level surface.
X20W = 453 kg (1000 lbs.) including 4 persons
Collision Hazard
NEVER position the platform
without first checking for
overhead obstructions or
other hazards.
Fall Hazard
NEVER climb, stand or
sit on platform
guardrails or midrail.