Towing Or Winching; Parking Brake Release; After Use Each Day - Upright X Série Guide De L'opérateur

060572-025 X Series
T W
OWING OR
Perform the following only when the machine will not operate under its own power and it is necessary to
move the machine or when winching onto a transport vehicle (see "Transporting the Work Platform" on
page 13).
C A U T I O N
DO NOT tow or winch the machine faster than 0,3 m/s (1 ft./s). Faster speeds will damage drive
components and void the warranty.
P
A R K I N G
Perform the following procedure only when the machine will not operate under its own power and it is nec-
essary to move the machine, or when winching onto a trailer to transport.
NOTE: X32N models have two identical brake
adjustment nuts located on both sides of the
ladder. The X20N, X20W, and X26N have only
one.
The Brake Adjustment/Release Nut(s) is/are
located at the rear of the machine to the right
and/or left of the ladder.
1. To release the brakes turn the nut(s) coun-
terclockwise until the brakes disengage the
tires.
2. The machine will now roll when pushed or
pulled.
3. To re-engage the brakes, turn the nut(s)
clockwise until the brakes have fully
engaged the tires. Verify that the brakes
have fully engaged the rear tires before
operating the machine by testing their abil-
ity to hold the machine on a 22% grade
(X32N 20%).
W A R N I N G
!
Never tow faster than 0,3 m/sec. (1 ft./sec.).
Never operate the work platform with the parking brakes released. Serious injury or damage could
result.
A
F T E R
1. Ensure that the platform is fully lowered.
2. Park the machine on a firm level surface, preferably under cover, secure against vandals, children and
unauthorized operation.
3. Turn the Chassis Key Switch to OFF and remove the key to prevent unauthorized operation.
Page 12
INCHING
B R
R A K E E L E A S E
U E D
S E A C H A Y

Parking Brake Release

!

Towing or Winching

Figure 6: Parking Brake Release
REAR
Parking Brake Release
REAR
Operation Manual