Offset Mode; Mac Address - Chauvet Professional MAVERICK MK2 WASH Manuel D'utilisation

Operation

Offset Mode

The Offset mode provides fine adjustments for the home position of all the moving parts in the optical path
and the pan and tilt movements. This allows the moving parts to not show any border or to reduce the light
output when in their home position. To access this mode, follow the instructions below:
1. Starting from the Main Level screen, press and hold <MENU> until the passcode screen appears.
2. Enter the passcode 2323 using one of the following methods:
• Through the touchscreen: use the number pad on the screen to enter 2323.
• With the buttons:
a. Use <DOWN> to select the number to be changed.
b. Use <UP> to increase the value.
c. Repeat until 2323 has been entered.
3. Press <ENTER>.
4. This brings you into the Zero Adjust menu screen.
PAN
To adjust the starting point of the pan motor, follow the instructions below:
1. Use <UP> or <DOWN> to select PAN.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to increase or decrease the starting value, from 000–255.
4. Press <ENTER>.
TILT
To adjust the starting point of the tilt motor, do the following:
1. Use <UP> or <DOWN> to select TILT.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to increase or decrease the starting value, from 000–255.
4. Press <ENTER>.
ZOOM
To adjust the starting point of the zoom motor, follow the instructions below:
1. Use <UP> or <DOWN> to select ZOOM.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to increase or decrease the starting value, from 000–255.
4. Press <ENTER>.

MAC Address

To adjust the fourth, fifth, or sixth digit of the MAC address, do the following:
1. Use <UP> or <DOWN> to select MAC4, MAC5, or MAC6.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to increase or decrease the value, from 000–255.
4. Press <ENTER>.
Maverick MK2 Wash User Manual Rev. 11 Page 48 of 267