Dual Control; Dual Control Movement - Chauvet Professional MAVERICK MK2 WASH Manuel D'utilisation

Operation

Dual Control

In Dual Control mode, the Maverick MK2 Wash is controlled by two protocol inputs. One controls the
movement of the yoke and zoom, and the dimmers and shutter, whereas the other controls the individual
LED output.

Dual control movement

The Movement protocol controls the movement of the yoke and zoom, and the dimmers and shutter.
Choose from DMX, Art-Net™, or sACN. In this mode, the three personalities available are: Basic
(8 channels), Standard (20 channels), and Advanced (26 channels).
Dual control movement protocol
To select the Dual Control Movement protocol, follow the instructions below:
1. Press <MENU> repeatedly until the
2. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Control Settings, or touch the display
where it says Control Settings.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP> or <DOWN> to select Dual Control, or touch the display where it says Dual Control.
5. If using the buttons instead of the touchscreen, press <ENTER>.
6. Use <UP> or <DOWN> to select Movement, or touch the display where it says Movement.
7. If using the buttons instead of the touchscreen, press <ENTER>.
8. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select from DMX, ArtNet, or sACN, or touch the
display where it says the desired protocol option.
9. If using the buttons instead of the touchscreen, press <ENTER>.
Dual control movement personality
To select the Dual Control Movement personality, set the Protocol, then do the following:
1. Use <UP> or <DOWN> to select Personality, or touch the display where it says Personality.
2. If using the buttons instead of the touchscreen, press <ENTER>.
3. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select from Basic (8-channel), Standard
(20-channel), or Advanced (26-channel), or touch the display where it says the desired
personality.
4. If using the buttons instead of the touchscreen, press <ENTER>.
Dual control movement start address
To set the starting address of the Dual Control Movement mode, set the Protocol, then follow the
instructions below:
1. Use <UP> or <DOWN> to select Start Address, or touch the display where it says Start Address.
2. If using the buttons instead of the touchscreen, press <ENTER>.
3. Enter the starting address (1–512) with one of the following methods:
• Type the address number using the number pad that shows on the touchscreen display.
• Using the buttons (or the button icons on the sides of the display):
a. Use <LEFT> or <RIGHT> to select the digit to be altered.
b. Use <UP> or <DOWN> to increase or decrease the number value of that digit.
c. Repeat until the address is set as desired.
4. Press <ENTER>.
Dual control movement universe
To set the Universe address of the Dual Control Movement mode when using Art-Net™ or sACN, set the
Protocol to ArtNet or sACN, then do the following:
1. Use <UP> or <DOWN> to select Universe, or touch the display where it says Universe.
2. If using the buttons instead of the touchscreen, press <ENTER>.
3. Enter the universe address (0–255) with one of the following methods:
• Type the address number using the number pad that shows on the touchscreen display.
• Using the buttons (or the button icons on the sides of the display):
a. Use <LEFT> or <RIGHT> to select the digit to be altered.
b. Use <UP> or <DOWN> to increase or decrease the number value of that digit.
c. Repeat until the address is set as desired.
4. Press <ENTER>.
Maverick MK2 Wash User Manual Rev. 11
Home Screen shows on the display. Press <ENTER>.
Page 16 of 267