Re-Attaching The Refrigerator Doors - Samsung RF24FSEDBSR Mode D'emploi

RE-ATTACHING THE
REFRIGERATOR DOORS
To reattach the fridge doors after you have moved
the fridge to its fi nal location, assemble the parts
in reverse order.
1. The Water Line must be fully inserted into the
center of the transparent coupler (Type A)
or the Guide Lines (Type B) to prevent water
leakage from the dispenser.
Type A Type A
Center of Transparent coupler Center of Transparent coupler
clip A (1/4") clip A (1/4")
(6.35 mm) (6.35 mm)
2. Insert the clip in the install pack and check that
it holds the line fi rmly.
DISASSEMBLING THE FLEX
DOOR
1. Take out the Flex Zone ( 1 ) by lifting it up.
2. Take off the cover ( 2 ) w/harness with a fl at-
blade screwdriver (-).
3. Press the locking tab and separate the Wire
Connector.
12_ setting up
DA68-02897A(0.1).indb 12 DA68-02897A(0.1).indb 12
Type B Type B
Dispenser Dispenser
The Guide Lines The Guide Lines
clip A (1/4") clip A (1/4")
(6.35 mm) (6.35 mm)
1
2
When reassembling it, be sure to connect
the wire harness.
CAUTION
If it is not connected, the Flex Room does
not work.
4. Remove 1 hex head bolt from each side with a
socket wrench (10mm).
5. Lift up the Flex door from the rails.
Putting too much food into the freezer
drawers can prevent the freezer from
CAUTION
closing completely and can cause frost
build-up.
13. 03. 13 오전 8:38 13. 03. 13 오전 8:38