Samsung RF24FSEDBSR Mode D'emploi page 11

With the door opened
1. Remove the 3 screws holding down the TOP
TABLE ( 1 ) and separate the connected wires.
2. Disconnect the two connectors ( 2 ) on the
left side door. To remove the water coupler
from the hinge, twist and pull it from the hinge.
Remove the water line ( 3 ) while pressing the
marked part ( 4 ) of the water line coupler.
If a red clip is on the coupler, you must
remove it before removing the tube.
CAUTION
2
Red Clip Red Clip
(1/4") (1/4")
3
4
3. Pull and remove the hinge lever ( 5 ). Remove
the ground screw ( 6 ) attached to the upper
left door hinges with a philips screwdriver (+).
Remove the upper left and right door hinges
( 7 ).
5
7
4. Open the door (more than 90°) , lift from the
middle hinge and remove the door.
- Due to its design features, you can
disassemble and re-assemble the Auto
Closing Hinge when the door is open. (The
holes in the Door Shaft and the Door Middle
Hinge are deliberately tilted at specifi c angles
so that it is diffi cult to disassemble and re-
assemble with the door closed.)
DA68-02897A(0.1).indb 11 DA68-02897A(0.1).indb 11
1
CAUTION
Door Middle Hinge Door Middle Hinge
- If the Auto Closing Hinge is aligned to be
vertical as shown in the fi gure, align it to be
parallel by using the Door Middle Hinge. (Refer
to No.5 for the disassembly of the Door Middle
Hinge)
CAUTION
5. Remove the screw ( 8 ) attached to the
lower left and right door hinges with a philips
6
screwdriver (+). Remove the 2 hex head bolts
( 9 ) attached to the lower left and right door
hinges with an allen wrench (3/16"). Remove
the lower left and right door hinges ( 10 ).
Place the door, inside facing up, on a non-
scratching surface.
Auto Closing Hinge Auto Closing Hinge
Do not give it too much force while rotating
it with a fl at head screwdriver. It may get
damaged.
10
8
9
Allen wrench Allen wrench
setting up _11
13. 03. 13 오전 8:38 13. 03. 13 오전 8:38