Ec Declaration Of Conformity; Warranty - AL-KO KE 2000/35 Mode D'emploi

GB

EC declaration of conformity

We hereby declare that this product, in the form in which it is marketed,
meets the requirements of the harmonised EU guidelines,
EU safety standards, and the product-specific standards.
Product
Electric chain saw
Serial number
KE 2000/35 G4104105
KE 2200/40 G4104106
KE 2200/40S G4104107
Model
KE 2000/35
KE 2200/40
KE 2200/40S
Sound power level
measured / guaranteed
KE 2000/35 101,7 / 103 dB(A)
KE 2200/40 101,7 / 103 dB(A)
KE 2200/40S 101,7 / 103 dB(A)
BM 1027 MSR
VDE Prüf- und Zertifizierungsinstitut
Merianstraße 28
D-63069 OFFENBACH AM MAIN
DEUTSCHLAND

Warranty

If any material or manufacturing defects are found during the statutory customer protection period, we will either repair or
replace the equipment, whichever we consider the more appropriate. This statutory period may vary according to the legisla-
tion in force in the country where the equipment was purchased.
Our warranty is valid only if:
„ The equipment has been used properly
„ The operating instructions have been followed
„ Genuine replacement parts have been used
The following are not covered by warranty:
„ Paint damage due to normal wear
„ Wear parts identified by a border XXX XXX (X) on the spare parts list
„ Combustion motors – these are covered by a separate warranty from the manufacturer concerned
To make a claim under warranty, please take this statement of warranty and proof of purchase to the nearest authorised
customer service centre. This warranty does not affect the usual statutory rights of the customer relative to the seller.
Manufacturer
AL-KO Geräte GmbH
Ichenhauser Str. 14
89359 KOETZ
DEUTSCHLAND
EU directives
2006/42/EC
2000/14/EC
2005/88/EC
2006/95/EC
2004/108/EC
Conformity evaluation
2000/14/EG
Appendix V
Notified body
VDE Prüf- und Zertifizierungsinstitut
Merianstraße 28
D-63069 OFFENBACH AM MAIN
DEUTSCHLAND
0366
The warranty is no longer valid if:
„ The equipment has been tampered with
„ Technical modifications have been made
„ The trimmer was not used for its intended purpose (for exa-
┌──────┐
└──────┘
Executive Officer
Anton Eberle
Ichenhauser Str. 14
89359 KOETZ
DEUTSCHLAND
Harmonised standards
EN ISO 11681-1:2008
EN 55014-1:2006
EN 55014-2:1997+A1
EN 61000-3-2:2006
EN 61000-3-3:1995+A1+A2
Antonio De Filippo, Managing Director
mple, used for commercial or communal applications)
Kötz, 2010-05-12