S&P TOWER-2000 PTC Notice D'installation Et D'utilisation page 11

Children should not play with the product.

Before carrying out any maintenance work, or during

long periods without use, make sure that the device
has been disconnected from the mains.
Do not clean the product while it is working and do not

immerse it in water.
Do not handle the heater with wet hands.

Do not coil the power cable around or on top of the

product while it is working.
If the cable gets damaged it must be replaced by S&P

– take the equipment to our official S&P because the
work must be done by specialist personnel to avoid
any risk of damage.
The heater must always work vertically, and the base

must be located on stable ground.
Only for internal use.

2. The product
 Description of the product (Figure 1):
A LCD screen
B Control panel
C Ceramic heater element (PTC)
D Base oscillation
E Safety tilt switch
F Feet main switch
G Remote control
H Receiver remote control
- Transport handle
- Input air filter
3. Use and operation
 Make sure the power supply corresponds to the details shown on the nameplate:
230 V ~ 50Hz.
 Before connecting the product to the power, make sure that it is located on a stable floor
and has a firm vertical position. Remember that as a safety feature, the product
incorporates a safety tilt switch under the base (Fig.1 D-E)
11