S&P TOWER-2000 PTC Notice D'installation Et D'utilisation page 13

4. Maintenance

Before carrying out any maintenance work, make sure that the device has been
disconnected from the mains and let the heater cool down for a few minutes.
 Periodically, to prevent accumulation of dust, remove the filter support of air inlet
(posterior part) acting on the two release tabs. Clean the filter with cold water and let
dry. Once dry, put it down again with your support.
Then clean the rest of the appliance and air outlet grille, with a cloth dampened with
water. Do not use detergents or abrasive products.
 Do not immerse the device or spray with water.
 If the appliance is not to be used for any length of time, we recommend returning it to its
original package and storing it in a dry, dust-free place.
5. Removal from service and recycling
 EU regulations and our commitment to future generations oblige us to recycle
used materials; please remember to dispose of all unwanted packaging materials at the
appropriate recycling points, and to drop off obsolete equipment at the nearest waste
management point
6. Technical asistance
S&P's large Technical Service network will guarantee satisfactory technical

assistance.
 If a fault is observed in the unit, please contact any of the mentioned technical service
offices and they will attend to your problem.
 Any modification of the appliance by personnel not belonging to the Official S&P
Services will result in your guarantee being void.
 For any queries regarding S&P products please contact any branch of our After Sales
Service network if you are in Spain, or your regular dealer in the rest of the world.
To find your nearest dealer, visit our website at www.solerpalau.com.
THE MANUFACTURER WILL NOT BE HELD LIABLE FOR DAMAGES TO PEOPLE AND/OR
PROPERTY DUE TO NON-COMPLIANCE WITH THESE WARNINGS.
S&P RESERVES THE
NOTIFICATION.
RIGHT TO MODIFY
13
THE PRODUCT WITHOUT PRIOR