How To Use; Getting Started; Programming Your Coffee Maker - Black & Decker CM1231BC Mode D'emploi

H OW TO U SE
This product is for household use only.

GETTING STARTED

1. Remove all packing material, any stickers, and the plastic band around the
power plug.
2. Go to www.prodprotect.com/blackanddecker to register your product.
3. Wash removable parts as instructed in CARE AND CLEANING.
4. Clean the inside of your coffeemaker by running two full brewing cycles with
water only, no coffee.
a. Pour fresh, cold water into the water reservoir up to the 12-cup MAX
mark, then place carafe onto the carafe plate.
b. Plug cord into standard electrical outlet.
c. Push the ON/OFF ( ) button to immediately brew water through the
coffeemaker without adding coffee.
d. Once the cycle is finished, discard water.
e. Turn off appliance, unplug and allow to cool down for 15 minutes
before repeating.

PROGRAMMING YOUR COFFEE MAKER

Setting the Digital Clock
1. Plug the coffeemaker into a standard electrical outlet.
2. The numbers and colon ":" on the digital clock display flashes "12:00".
3. Press HOUR and MIN buttons to set time:
Press HOUR button until the correct time
appears on the display. The colon ":" will
continue to flash even after the time is set. (A)
4. When the time passes noon the LED light
next to PM illuminates to let you know you are
in PM time. If the PM light is not illuminated it
is AM time.
5. To change time, use HOUR and MIN buttons
at any time.
Note: If the appliance is unplugged or power is
interrupted even momentarily, the time may need
to be reset.
6