Noise And Vibration; Machine Inspection; Machine Operation; Quick Start - NSS CHARGER 2717 AB Instructions D'origine

NOISE AND VIBRATION

NOISE
Sound pressure level at Operator
position (ISO 11201)
VIBRATION
Weighted RMS acceleration value
(ISO 5349)

MACHINE INSPECTION

 Now that the machine is unpacked remember to
recycle all packing materials.
 Inspect the machine for damage or missing
components. If damage is found, contact the freight
company to file a freight claim.

MACHINE OPERATION

General Information
This machine works best with dry polishing or
burnishing. Use mop on restorers rather than spray buff
systems to restore the shine.
Spray buffing is time consuming and uses more pads
because they become loaded with floor finish, which
can cause overloading of the machine's control system.

Quick Start

Connecting Battery Pack to Machine
When the machine is shipped with batteries, the
machine will arrive with the battery pack disconnected
from the machine.
 Lift up on the handle on the top cover to expose the
battery pack.
 Connect the cable with the Anderson connector into
the Anderson connector mounted to the machine at
the rear of the battery compartment in front of the
control column.
For machines shipped without batteries
 See Battery Installation in the Maintenance Section
later in this manual.
Lower Brush/Pad to Operating Position
68 dB(A)
2
.269 m/s
 Move the front of the machine from/to pad changing
position or operating position by grasping the handle
and moving it to the desired position.
 Turn on master switch (and key switch if so
equipped). Wait until you hear a click, the machine is
now on. See Machine Components for more
information.
 Check that the battery meter is reading in the high or
green range. The machine should be put on charge if
not in the high range. See Charging Instructions later
in this manual.
 Turn on brush switch. See Machine Components for
more information.
 Push the machine slightly and twist the handle grips
forward (away from you) to activate the Pad Motor.
CAUTION: This Machine must be moving at all times
when the pad is rotating or the floor may be damaged.
Transporting the Machine to Work Site
NSS recommends transporting the machine to the work
site with the front of the machine in the operating
position and the brush switch in the off position. This will
reduce the potential of damage to the Flexiwall Shield
and Pad Driver when moving through stock/storage
rooms and double swinging doors.
For questions and all information pertaining to this
machine read the rest of this manual.