Charging Batteries - NSS CHARGER 2717 AB Instructions D'origine

Daily Maintenance (continued)
 Empty the filter bag daily or when it is approximately
one-half (1/2) full.

Charging Batteries

 Recharge the batteries when indicated by the Battery
Meter.
 Never let the batteries sit overnight after the machine
has been run for 1hr or more since last recharge.
 NEVER let the electrolyte level fall below the tops of
the plates. This will damage the batteries
immediately, and void the warranty.
 Check charger cord for exposed wires and damaged
plugs before using.
 To recharge the batteries plug the charger cord into
the charger located on top of the machine and then
into an electrical outlet.
 When the cord is plugged into an outlet the machine
will automatically become disabled.
 Charge the batteries with the cover open when
possible to reduce heat buildup in the batteries.
 See charging instructions for more details.
 ALWAYS wear eye protection, rubber gloves and
protective clothing to avoid contact with battery acid
when working around batteries.
 After charging batteries check the water level of each
battery cell and add distilled water as required to level
specified by battery manufacturer.
 Check and verify that all battery connections are
clean and tight.
 Wipe machine down with a damp cloth.
 NEVER spray this machine with water or any liquids.
 ALWAYS Check the tilt switch for proper operation.
With the master switch turned off, put the brush head
into the pad change position. Turn the brush switch
on then the master switch on, the machine should
turn on.
 If the machine does not turn on and the battery meter
is flashing a one, the tilt switch has failed. DO NOT
use the machine until the tilt switch has been
replaced.
Opportunity Charging
Opportunity charging is charging the batteries when an
opportunity presents itself, such as during breaks, and
is done in addition to a full charge cycle.
Opportunity charging is recommended, as this extra
charging time will help raise the operating voltage of the
batteries, and will help ensure maximum runtime and
cycle life.
See Monthly Maintenance and Operating Battery
Charger Instructions for equalizing your batteries
especially if you have been opportunity charging
your machine.
Weekly Maintenance
(Every 25 Hours)
Verify all daily maintenance has been performed.
 Inspect the Flexiwall Shield for dents around the
outside edge and cracks in the plastic.
 Check that the Brush and Retaining Band are
properly installed.
 Remove dirt build up on the brush along the bottom of
the Flexiwall Shield.
 A damaged Flexiwall Shield Assembly will greatly
reduce dust control capabilities of the machine.