Machine Components - NSS CHARGER 2717 AB Instructions D'origine

MACHINE COMPONENTS

Operator Control Column
The operator control column is located at the rear of the
machine. This column has components that control
various machine functions.
Pad System Control
 At the top on both sides of the control column are two
(2) rubber twist grips. These grips rotate forwards to
activate the Pad Motor.
 These twist grips have a safety feature that returns
them to the off position when the handles are
released.
 Push the machine slightly and twist the handle grips
forward (away from you) to activate the Pad Motor.
Battery Meter
The battery meter is located in the back of the control
column cover and has two uses. It shows the state of
charge of batteries during operation and flashes fault
codes when there is a problem with the machine.
 The rate of charge is indicated by numbers. The
higher the number the greater the charge in the
battery pack.
 When there is a fault with the machine, the Battery
Meter will flash an "F" followed by a number.
 See Trouble Shooting Chart for more information.
Battery Charger
The battery charger is located on top of the battery box
cover.
 This high efficiency battery charger is designed for
onboard operation.
Master Switch
 The master switch is located on the top right side of
the control column and it turns the machine on and
off.
 If the brush switch is on and the brush head is down
or the twist grips are not in the off position the
machine will not turn on. A flashing fault code will
appear on the battery meter. See the bottom of the
decal on control column cover and correct the
problem.
 The control system will automatically turn the
machine off if it sets idle for 10 minutes. Turned off
the master and brush switch and then turn the master
switch back on to restart.
Hour Meter
 The hour meter is located under the Master Switch
and counts the hours the brush motor is on. The hour
meter is used for indicating maintenance intervals.
The hour meter cannot be reset.
 See maintenance section for maintenance intervals.
Fuse Holder
 The fuse holder is located under the Hour Meter. It
houses a 2 AMP fuse.
Key Switch
 A Key Switch is Optional and will be located above
the hour meter when installed. The key switch and
master switch will both need to be used to turn the
machine on and off.