Installation And Connection; Radio Interference; Grounding Instructions - Beko MCF25210X Manuel D'instructions

3 Installation and connection

3.1 Installation
1. Make sure that all the packing materials are re-
moved from the inside of the door.
WARNING: Check the oven for any
damage, such as misaligned or bent
door, damaged door seals and seal-
A
ing surface, broken or loose door
hinges and latches and dents inside
the cavity or on the door. If there
is any damage, do not operate the
oven and contact qualified service
personnel.
2. This microwave oven must be placed on a flat,
stable surface to hold its weight and the heavi-
est food likely to be cooked in the oven.
3. Do not place the oven where heat, moisture, or
high humidity are generated, or near combus-
tible materials.
4. For correct operation, the oven must have suffi-
cient airflow. Allow minimum 20cm of free spa-
ce necessary above the top surface of the oven
and 5cm at both sides. The microwave oven
rear plate must be placed close to the wall. Do
not cover or block any openings on the applian-
ce. Do not remove feet.
5. Do not operate the oven without glass tray, roller
support, and shaft in their proper positions.
6. Make sure that the power supply cord is unda-
maged and does not run under the oven or over
any hot or sharp surface.
7. The socket must be readily accessible so that it
can be easily unplugged in an emergency.
8. Do not use the oven outdoors.

3.2 Radio interference

Operation of the microwave oven can cause in-
terference to your radio, TV, or similar equipment.
When there is interference, it may be reduced or
eliminated by taking the following measures:
1. Clean door and sealing surface of the oven.
Microwave Oven / User Manual
2. Reorient the receiving antenna of radio or te-
levision.
3. Relocate the microwave oven with respect to
the receiver.
4. Move the microwave oven away from the re-
ceiver.
5. Plug the microwave oven into a different outlet
so that microwave oven and receiver are on dif-
ferent branch circuits.

3.3 Grounding instructions

This appliance must be grounded. This oven is
equipped with a cord having a grounding wire with
a grounding plug. It must be plugged into a wall
receptacle that is properly installed and grounded.
In the event of an electrical short circuit, ground-
ing reduces risk of electric shock by providing an
escape wire for the electric current. It is recom-
mended that a separate circuit serving only the
oven be provided. Using a high voltage is dan-
gerous and may result in a fire or other accident
causing oven damage.
A
WARNING: Improper use of the
grounding plug can result in a risk of
electric shock.
If you have any questions about the
C
grounding or electrical instructions,
consult a qualified electrician or ser-
vice person.
Neither the manufacturer nor the
dealer can accept any liability for
C
damage to the oven or personal
injury resulting from failure to ob-
serve the electrical connection pro-
cedures.
The wires in this cable main are colored in accord-
ance with the following code:
Green and Yellow = EARTH
Blue = NEUTRAL
Brown = LIVE
13 / EN