Dimplex LIH 10TE Instructions D'installation Et D'utilisation page 52

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

LIH 10TE
X1
Klemmenleiste: Einspeisung
X2
Klemmenleiste: Spannung = 230VAC
X3
Klemmenleiste: Kleinspannung < 25VAC
X5
Klemmenleiste: E10
XM2
Klemmenleiste: M2
Y1
Vier-Wege-Ventil
*
Bauteile sind bauseits anzuschließen / beizustellen Components must be connected / supplied by the
____
werkseitig verdrahtet
------
bauseits nach Bedarf anzuschließen
ACHTUNG!
An den Steckklemmen J1 bis J11, J24 und der
Klemmleiste X3 liegt Kleinspannung an. Auf
keinen Fall darf hier eine höhere Spannung
angelegt werden!
A-X
Terminal strip: Infeed
Terminal strip: Voltage = 230 VAC
Terminal strip: extra-low voltage < 25VAC
Terminal strip: E10
Terminal strip: M2
Four-way valve
customer
wired ready for use
to be connected by the customer as required
ATTENTION!
Plug-in terminals J1 to J11, J24 and terminal
strip X3, are connected to an extra-low voltage
supply. A higher voltage must on no account
be connected!
452165.66.01 · FD 9502
Bornier distributeur : Alimentation
Bornier distributeur : Tension = 230 VAC
Bornier distributeur : Faible tension < 25 VAC
Bornier distributeur : E10
Bornier distributeur : M2
Vanne 4 voies
Les pièces sont à raccorder / à fournir par le client
câblé en usine
à raccorder par le client si besoin
ATTENTION !
Une faible tension est appliquée aux bornes
enfichables J1 à J11, J24 et au bornier X3. Ne
jamais appliquer une tension plus élevée !.
www.dimplex.de

Publicité

Chapitres

Table des Matières
loading

Table des Matières