IKEA Betrodd Manuel D'instructions page 10

OPTION SELECTIONS
Dries dishes with heat. This option, with the use of
rinse aid, will provides better drying performance.
Plastic items are less likely to deform when loaded
in the top rack. Use Heat Dry for optimum dry
performance. Turn the Heat Dry option off for air dry.
Raises main wash temperature to improve cleaning
for loads containing tough, baked-on food.
Sanitizes dishes and glassware in accordance
with NSF International NSF/ANSI Standard 184
for Residential Dishwashers. Certified residential
dishwashers are not intended for licensed food
establishments. Only sanitizing cycles have been
designed to meet the requirements of the NSF/
ANSI 184 performance standard for soil removal
and for sanitization efficacy. There is no intention,
either directly or indirectly, that all cycles on a NSF/
ANSI 184 certified dishwasher meet the NSF/ANSI
184 performance standard for soil removal and for
sanitization efficacy.
At end of the cycle, the "Sanitized" indicator will
glow. If your load did not properly sanitize, the
indicator will flash at the end of the cycle. This can
happen if the cycle is interrupted, or if the water
does not reach the required temperature. The light
goes off when you open and close the door or
press CANCEL.
Delays the start of the cycle for 4 hours.
To delay the start:
1. Select a wash cycle and options.
2. Press DELAY WASH.
3. Press START/RESUME to begin 4 hour delay.
NOTE: If the door is opened (such as to add a dish),
the Start/Resume button must be pressed to resume
the delay countdown.
CONTROLS AND CYCLE STATUS
10
OPTIONS
Press to start or resume a wash cycle.
If the door is opened during a cycle or the power is interrupted, the Start/Resume LED flashes. The cycle
will not resume until the Start/Resume keypad is pressed and the door is closed.
NOTE: Push door firmly closed within 4 seconds of pressing Start/Resume or the dishwasher will not
start. If door is not closed within 4 seconds the Start/Resume LED will flash and an audible tone will
sound when the door is closed.
Press to cancel a wash cycle. then, close the door firmly. The dishwasher starts a 2-minute drain
(if needed). Let the dishwasher drain completely.
Use the Control Lock option to avoid unintended use of the dishwasher between cycles. When the
Control Lock indicator is lit, all keypads are disabled. The dishwasher door can still be opened/closed
while the controls are locked.
CAN BE WHAT IT DOES ADDED
SELECTED
WITH
Sensor Uses heating
Heavy element to speed
Normal drying times.
ECO Heat Dry option
1 Hour defaults to On
when any cycle is
selected, except
for 1 Hour and
Rinse Only.
Sensor Raises the main
Heavy wash temperature
Normal to 130°F (54°C).
Sensor Raises the main
Heavy wash temperature
Normal to 140°F (60°C)
and the final rinse
temperature to
156°F (69°C).
Available with
Delays the start
any cycle of a cycle for a
maximum of
4 hours.
ADDED
TIME TO WATER
CYCLE GALLONS
(LITERS)
0:10 to 0
0:46
0:05 to 0 to 3.86
0:13 (0 to 14.6)
0:05 to 0 to 3.86
1:10 (0 to 14.6)