Leister COMET Instructions D'utilisation page 24

Adjustment of the welding parameters
Welding temperature
Set the welding temperature with the
the ambient temperature. The in-put SET value will be shown on the display. Switch on the heating by pressing the
+
and keys simultaneously. Heating up time approx. 5 mins.
H
Heating
Welding Speed
According on the film or geomembrane liner and the influence of the weather, set the welding speed with the
– +
keys. The in-put SET value will be shown to the display.t.
Drive
24
–
+
H
cursor will blink on
H
the display
–
+
+
&
H
– +
M
keys. The temperature is dependent on the material and
SET value setting
ON/OFF
SET value adjustment
ON/OFF