Automatic Switch-Off; The Heat Setting; Bridge Function; Automatic Heat Up - Electrolux EHL7640FOK Mode D'emploi

4.2 Automatic Switch Off
The function deactivates the
appliance automatically if:
• All cooking zones are deactivated (
).
• You do not set the heat setting after
you activate the appliance.
• You spill something or put something
on the control panel for more than 10
seconds, (a pan, a cloth, etc.). An
acoustic signal sounds some time and
the appliance deactivates. Remove the
object or clean the control panel.
• The appliance becomes too hot (e.g.
when, a saucepan boils dry). Before
you use the appliance again, wait for
the cooking zone to cool down.
• You use incorrect cookware. The sym-
bol comes on and the cooking zone
deactivates automatically after 2 mi-
nutes.
• You do not deactivate a cooking zone
or change the heat setting. After some
time comes on and the appliance
deactivates. See below.
• The relation between heat setting and
times of the Automatic Switch Off func-
tion:
•
, - — 6 hours
•
- — 5 hours
•
- — 4 hours
•
- — 1.5 hours

4.3 The heat setting

Touch the control bar at the heat setting.
Move your finger along the control bar to
change the setting. Do not release before
you have a correct heat setting. The dis-
play shows the heat setting.

4.4 Bridge function

The Bridge function connects two cook-
ing zones and they operate as one.
First set the heat setting for one of the
cooking zone.
To activate the Bridge function for left/
right cooking zones touch
or change the heat setting touch one of
the left/right control sensors.
To deactivate the Bridge function touch
/ . The cooking zones operate in-
dependently.

4.5 Automatic Heat Up

You can get a necessary heat setting in a
shorter time if you activate the Automatic
Heat Up function. This function sets the
highest heat setting for some time (see
the diagram), and then decreases to the
necessary heat setting.
To start the Automatic Heat Up function
for a cooking zone:
1.
Touch ( comes on in the dis-
play).
2. Immediately touch the necessary heat
setting. After 3 seconds
in the display.
To stop the function change the heat set-
ting.
ENGLISH 25
/ . To set
comes on