Fermax Skyline DUOX PLUS Manuel D'installation page 25

Masquer les pouces Voir aussi pour Skyline DUOX PLUS:
Table des Matières

Publicité

2º. Manteniendo el cortocircuito anterior conecte la alimentación del sistema, (ya no
será necesario mantener el cortocircuito o el pulsador presionado). En ese momento el
amplificador generará tantos ''bips'' como segundos haya programado para el tiempo de
apertura desde vivienda.
2.1.Si se desea cambiar ese valor se debe pulsar cualquier botón de llamada tantas
veces como segundos se quiera programar.
2.2.Si no se quiere cambiar basta con dejar pasar 5" sin pulsar ningún botón de llamada.
3º. Después el amplificador generará tantos ''bips'' como segundos haya programado para
el el tiempo de apertura desde el pulsador de salida.
3.1.Si se desea cambiar ese valor se debe pulsar cualquier botón de llamada tantas
veces como segundos se quiera programar.
3.2.Si no se quiere cambiar basta con dejar pasar 5" sin pulsar ningún botón de llamada.
4º. Salir de programación:
Para salir de programación, permanecer 5 segundos sin pulsar ninguna tecla. Sonará un
''bip bip'' indicando la salida de programación de tiempos.
Notas:
• Valores:
- Tiempo abrepuertas: 01..99 seg. (por defecto: 03).
- Tiempo botón salida: 00..99 seg. (por defecto: 06).
RESET de parámetros a valores por defecto de fábrica (mediante un teclado)
Se puede realizar un Reset de parámetros a valores por defecto de fábrica. Para ello es
necesario conectar temporalmente un teclado (ref. 7439) para introducir los valores numéricos.
Descargar el manual de Programación Placas Direct, cod. 97701, en www.fermax.com.
RESTORE DEFAULT VALUES: Reset
The DUOX amplifier has a 'Reset' function which can be used to restore programmed default
parameters.
RESET Mapping (call button code)
1º Reset amplifier: remove power.
2º With the SW1 button pressed, power and maintain the SW1 button for 5 seconds, until
you hear the confirmation sound: beep-beep.
Lock-release times / Configuration of parameters
There are two programmable lock-release activation times:
- Lock-release time set from the residence.
- Lock-release time set from the exit button (connected to the 'BS' and '-' terminals).
Carry out the following steps:
1º With the power supply disconnected, short circuit the «Bs» and «-» (negative) amplifier
terminals (or press the exit button when one exists).
2º Maintaining the short-circuit induced above, connect the system's power supply (at this
point it will no longer be necessary to maintain the short circuit or hold down the button). At
this time the amplifier will ''beep'' for every second the opening time has been pro-grammed
for from the residence.
KIT AUDIO SKYLINE DUOX PLUS 3-12 L
25

Publicité

Table des Matières
loading

Table des Matières