CAME ZLJ14 Manuel D'installation page 26

Command and control devices Command and control devices
⚠ Before fitting any snap-in cards (such as the AF or R700), YOU MUST CUT OFF THE POWER MAINS, and disconnect the power
mains.
Transponder or
card reader
Stop button (NC contact). For stopping the gate leaves while excluding
automatic closing. To resume movement press the control button or
use another control device.
 If unused, select [Disabled] from the [Total Stop] in the
[FUNCTIONS].
OPEN ONLY function from control device with NO
contact.
PARTIAL OPENING feature from command device (NO
contact).
See the [Partial open] function, for opening times in the
[SET TIMES] menu.
ONLY CLOSE function from control device (NO
contact).
OPEN-STOP-CLOSE-STOP sequential function /
OPEN-CLOSE-INVERT step-step from a control
device (NO contact).
See the [2-7 command] in the [FUNCTIONS].
 Fit the R700 decoding card for recognition of the TSP00
sensor or the LT001 card reader.
M E
C A
Red
Black
X C C Y X CY CZ
 Fit the AF card to control the operator
via transmitter.
2 FA FC B1 B2 S1 GND
Antenna with RG58 cable