CAME ZLJ14 Manuel D'installation page 23

Description of parts
1. Transformer
2. Power supply on warning LED
3. Display
4. Memory roll board connector
5. Programming buttons
6. Programming warning LED
7. Display brightness adjusting trimmer
8. Connector for the R700 card
9. AF card connector
10. Antenna terminal
11. Terminals for transponder
12. Endstop terminals
13. Terminals for control and safety devices
14. Encoder terminals
15. Terminals for gearmotors
16. Power supply terminals
17. Line fuse
18. Control-board fuse
19. Electric-lock fuse
20. Motor fuse
21. Accessories fuse
GENERAL INSTRUCTIONS FOR INSTALLING
⚠ Only skilled, qualified staff must install this product.
⚠ Before working on the control panel, cut off the main current supply and, if present, remove any batteries.
Preliminary checks
⚠ Before installing the control panel it is necessary to:
• make sure that the point where the control panel is fastened is protected from any impacts and that the anchoring surface is solid enough, and
that proper tools are used (that is, screws, anchors, and so on); • make sure you have set up a suitable dual pole cut off device along the power
supply that is compliant with the installation rules. It should completely cut off the power supply according to category III surcharge conditions
(that is, with minimum contact openings of 3 mm);
• Make sure that any connections inside the container (ones that ensure continuity to the protection circuit) are fitted with additional insulation
with respect to those of other electrical parts inside.
Tools and materials
Make sure you have all the tools and materials you will need for installing in total safety and in compliance with applicable regulations. The figure
shows some of the equipment installers will need.
1
21
L1T L2T 24 12
20
19
18
17
120V=3,15A-F
230V=1,6A-F
M N ENC + E -
L N
10 11 TS
16 15 14
0
2 FA FC B1 B2
E E3 ES 1 2 3 3P 4 5 7 CX CY CZ
13 12
2
3
4
5
6
7
8
9
S1 GND
11 10