DITEC Obbi 3BH Manuel D'installation page 13

Operating instruction Obbi 3BH
LEFT PISTON
Attention: Lock and release operations must be performed with motor not running.
RELEASE INSTRUCTION
In case of faulty operation or power failure, unlock the electric lock, if mounted, insert the key and rotate the key
anticlockwise (as indicated by the arrow on the geared motor). Manually slide the gate open.
LOCK INSTRUCTION
To relock the wings, turn the key clockwise (counterwise to the direction of the arrow on the geared motor). To
facilitate the operation, slightly move the gate wing.
GENERAL SAFETY PRECAUTIONS
The following precautions are an integral and essential part of the product and must be supplied to the user.
Read them carefully as they contain important indications for the safe installation, use and maintenace.
These instruction must be kept and forwarded to all possible future user of the system.
This product must be used only for that which it has been expressely designed.
Any other use is to be considered improper and therefore dangerous.
The manufacturer cannot be held responsible for possible damage caused by improper, erroneous or unresonable use.
Avoid operating in the proximity of the hinges or moving mechanical parts.
Do not enter the field of action of the motorised door or gate while in motion.
Do not obstruct the motion of the motorised door or gate as this may cause a situation of danger.
Do not allow children to play or stay within the field of action of the motorised door or gate.
Keep remote control or any other control devices out of the reach of children, in order to avoid possible involuntary activation of the
motorised door or gate.
In case of breack down or malfunctioning of the product, disconnect from mains, do not attempt to repair or intervene directly and contact
only qualified personnel.
Failure to comply with the above may create a situation of danger.
All cleaning, maintenance or repair work must be carried out by qualified personnel.
In order to guarantee that the system works efficiently and correctly it is indispensable to comply with the manufacturer's indications thus
having the periodic maintenance of the motorised door or gate carried out by qualified personnel.
In particular regular checks are recommended in order to verify that the safety devices are operating correctly.
All installation, maintenance and repair work must be documented and made available to the user.
DITEC S.p.A.
Via Mons. Banfi, 3
21042 Caronno P.lla (VA) Italy
Tel. +39 02 963911 - Fax +39 02 9650314
www.ditec.it
Electromechanical automatic system for swing gates
ISO 9001 - Cert. n° 0957/0
RIGHT PISTON