Function And Operation - koban KMOS-01 Mode D'emploi

Oscilloscope Section
•
To avoid electric shock, don't touch the metallic part of the probe top while connecting to
voltage source.
•
Measured signal by the oscilloscope is taken as a reference voltage to the ground, make sure
the ground terminal connect to the earth correctly, do not cause a short circuit.
- -
1 3 2 Probe application
1. Connect the oscilloscope probe with the connector, and insert into the input terminal of the
device.
2. If use probe hooked head, make sure the hook end firmly stuck in the probe.
3. Probe connection mode must be adopted while the measuring frequency of the signal is
above 1 Khz.

2.Function and Operation

In order to operate the oscilloscope efficiently, user needs to know the following
functions:
•
Interface and buttons
•
Connector and probe
•
Settings of system
•
Vertical system
•
Horizontal system
•
Trigger system
•
Signal capture system
•
Display system
•
Measuring system
•
Memory system
•
Auxiliary system
•
Online help system
-
2 1 Interface and Buttons
See the following picture:
Picture 2-1
•
Please follow the prompts of display interface for the use
of F1-F4.
•
HOLD hold key (freezes all the readings in the display)
•
MODE function key switch (switch the cursor and waveform
position)
•
AUTO auto search key (search waveform of unknown
frequency or amplitude)
•
REC record key (record current waveform content, the length is 10 pages)
•
direction key (adjust sample rate, preselecting amplitude and etc.)
42