General Safety Requirements - koban KMOS-01 Mode D'emploi

Oscilloscope Section

General safety requirements

Know about the following safety precautions to avoid personal injury, also to prevent damage
generated by connection of this product with any other product. In order to avoid any potential
danger, please use the product according to the regulation.
Only qualified technical personnel can take the maintenance procedures.
Prevent fire disaster or personal injury.
Use proper charger. Only special charger for this product confirmed by user's country is
available.
Insert and pull out correctly. Don't insert or pull out while test wire is connecting with power
cable.
Connect the probe correctly. Probe ground wire is the same as earth potential; please don't
connect the ground wire to a high voltage. During the test procedure, please don't touch bare
contacts or components.
Check all the terminal ratings. In order to prevent danger of fire and electrical shock, please
check all the ratings and notes of this product.
Before connecting the device, please read the user manual for further information of concerned
ratings.
Don't operate with the cover opened. If the cover-plate or face-plate is removed, please don't
use the device.
Use proper fuse wire. Only the fuse wires which compliances with specified type and ratings
of this product can be adopted.
Don't operate while suspecting product malfunction. If suspect any damage of this device,
please inform qualified maintenance personnel to examine.
Avoid circuit exposure. Don't touch any bare contact or component after connection of industrial
frequency power.
Please don't operate under an inflammable or explosive circumstance.
Keep device surface clean and dry.
39