koban KMOS-01 Mode D'emploi page 213

True RMS Multimeter
4-4.Page Area
The page area of the display is where the main meter content is displayed.
The primary display (upper half of the page area) is where the most important value of the
selected function is shown. The secondary display contains the bar graph and values that may
be measured in addition to the primary function value. For example, with frequency measurement
selected in Vac, the frequency value will appear in the primary display with the ac voltage value
in the secondary display.
4-5.Softkey Labels
Labels for the four function softkeys (F1 through F4) appear in the bottom row of the display.
These labels will change based on the function and/or menu selection.
4-6.Understanding the Rotary Switch
Select a primary measurement function
by positioning the rotary switch to one of
the icons around its perimeter. For each
function, the Meter presents a standard
display for that function (range, measurement units, and modifiers). Button
choices made in one function do not carry over into another function.
DC(AC) and AC+DC voltage measurements
AC voltage measurements
DC(AC) millivolts, ac+dc millivolt measurements
Frequency measurements
Resistance, Diode test, Capacitance and Continuity measurements
Temperature measurements
AC, DC and AC+DC amps measurements
AC, DC and AC+DC milliamps measurements
AC, DC and AC+DC microampere measurements up to 5,000 A
4-7.Using the Input Terminals
All functions except current use the VOHMSand COM input
terminals. The two current input terminals (A and mA/ A) are
Used as follows:
Current from 0 to 500 mA, use the uAmA and COM terminals.
Current between 0 and 10 A use the A and COM terminals.
Input for 0 A to 10.00 A current (20VA overload for 30 seconds
on, 10 minutes off),
Input for 0 A to 500 mA current measurements.
Return terminal for all measurements.
Input for voltage, continuity, resistance, diode test, conductance,
capacitance.
10
V
OSC
Hz
%
mV
10A
Temp
Hz
%
mA
Ω
μA
CAP
μ
μ
V Ω CAP
Temp Hz
%
CAT III 600V