Using The Device; Cleaning And Storage - gourmetmaxx Z 02733 Mode D'emploi

Using the device

1. Assemble the device as described in the chapter "Assembling the device".
2. Set up the device on a level, non-slip surface.
3. Only connect the device to a properly installed socket. The socket must also be easily
accessible after the device has been connected.
4. Place a bowl under the opening of the fi ll chute or holder for the cutting insert to collect
your food.
5. Turn on the device by pushing the On / Off switch.
6. Insert the food to be processed in the fi ll chute.
7. Use the plunger to push down food.
8. Push the On / Off switch again to turn off the device.
9. Disconnect the plug from the socket after use.
10. Clean the device and accessories after every use as described in the chapter "Cleaning and
storage".

Cleaning and storage

ATTENTION!
❐ Prior to each cleaning, pull the plug out of the socket.
❐ Never submerge the motor unit in water or other liquids.
❐ Be careful when handling the cutting inserts, the blades are sharp!
❐ When cleaning, do not use any scouring or abrasive cleaners. They could damage the surface.
• If necessary, wipe the motor unit off with a damp, soft cloth. Then wipe the device off
completely with a dry cloth.
• Clean the holder for the cutting insert, cutting inserts, fi ll chute and plunger with clean, warm
water and a small amount of mild detergent.
• Store the device in a dry area that is not accessible to children and animals.
3. To remove the holder for the cutting insert, turn the rotating
fastener towards the OPEN arrow in order to open the
fastener.
4. Take the holder for the cutting insert off of the drive shaft.
21