LD Systems LDMEI100G2 Manuel D'utilisation page 8

REAR pANEL TRANSMITTER:
1
1
POWER PACk INPUT
2
STEREO/MONO SWITCH
Stereo mode: Both line inputs, left and right, must
be used in order to hear a stereo signal on the
receiver. It is advisable to set the left and right line
inputs to the same level.
Mono mode: Only one line input must be used in order
to hear a mono signal on both sides of the earphones.
If there are different signals on both line inputs,
they are merged into sum mono signal. The
loudness of the two signals is then adjusted using
the left and right channel input level controls.
3
XLR / 6.3 MM jACk SOCkET (COMBO) INPUT
LEFT
8
2 3 4 5 6
4
XLR / 6.3 MM jACk SOCkET (COMBO) INPUT
RIGHT
5
INPUT LEVEL
Left channel
6
INPUT LEVEL
Right channel
7
ANTENNA jACk
50Ω
7