Setup And Troubleshooting - LD Systems LDMEI100G2 Manuel D'utilisation

SETUP AND TROUBLESHOOTING:

SETUP
For optimal transmission, position the transmitter at a minimum height of 1 m and orient the antenna vertically
upwards. When using multiple wireless systems in one installation, make certain that the antennas do not touch
or cross. Do not position the transmitter in the immediate vicinity of metal objects and digitally controlled devices
(CD players, computers, digital consoles, etc. ): There should be a direct line of sight between transmitter and
receiver.
TROUBLESHOOTING
PROBLEM
No sound or volume
too low.
Distortion or noise.
Distorted sound.
12
DISPLAY
Receiver: Display is switched off.
Transmitter: Display is switched off.
Receiver: is on, but the RF indicator
is not lit.
Receiver: is on and the RF indicator
is lit.
Receiver: RF indicator is on.
Receiver: Battery symbol is flashing.
Transmitter: Level indicator is too
high
SOLUTION
Make certain that the batteries are not dead
and the receiver is on.
Check the connection between power sup-
ply and transmitter. Turn on the transmitter.
Make certain that the transmitter and recei-
ver are set to the same radio frequency.
Reduce the distance between transmitter
and receiver and make certain that there
is a direct line of sight between transmitter
and receiver.
Make certain that the transmitter antenna is
installed correctly.
Increase the volume at the receiver and
check the headphone connection.
Check the input level on the transmitter and
increase it if necessary.
Increase the distance to possible causes
of interference (digitally controlled devices,
e.g., CD players, computers, digital conso-
les...).
Use a different radio frequency.
Replace the batteries with new ones.
Reduce the volume at the level controls of
the transmitter or the volume of the source
device.