Configuration; Configuration Of Optical Line And Star Topologies; Configuration Of Redundant Optical Rings - Siemens 6GK1970–5CA20–0AA2 Instructions De Montage

6 Configuration

6 Configuration
During configuration, the PROFIBUS network parameter "Slot time" must be adapted to the network coverage,
network topology and the data rate due to frame delays caused by lines and network components, as well as by
monitoring mechanisms in the network components.

6.1 Configuration of optical line and star topologies

The PROFIBUS network is configured, e.g. with SIMATIC STEP 7 (V5) or COM PROFIBUS (V5). The number of OLMs
(Number ) and overall line lengths can be entered in an input mask. The configuration tools control whether the
OLM
slot time in the selected communications profile can be retained. If this time is exceeded as a result of additional OLM
and optical fiber line runtimes, an error message is issued and the parameters are adapted accordingly.

6.2 Configuration of redundant optical rings

The following configuration conditions must be fulfilled in the redundant optical ring
(for details see Chap. 3.3 "Redundant optical ring", p.13):
(1) Configuration of a non-existent bus subscriber
(2) Increasing the retry value to at least 3
(3) Checking and adjusting the slot time
Use the user-specific profile of the configuration tool to set the parameters under (2) and (3).
Calculate the slot time with the following equation:
.
Slot time = a + (b Length
"Slot time"
"Length "
OF
"Number "
OLM
The factors a, b and c are dependent on the transmission rate and are listed in the tables below.
Version 1.1 8/00
.
) + (c Number
OF
is the monitoring period in bit times
is the sum of all the optical fiber lines (segment lengths) in the network.
The length must be given in km!
is the number of PROFIBUS OLMs in the network.
6.1 Configuration of optical line and star topologies
)
OLM
29