Humidity And Ultrasonic; Save Settings; Auto" Comfort Mode; Controlling Humidity - Boneco U350 Mode D'emploi

HUMIDIT Y AND ULTR ASONIC

SAVE SETTINGS

The BONECO U350 saves the last-used settings when it
is switched off. However, if the appliance is disconnected
from the power supply for a few seconds, it will start in
the operating mode.

"AUTO" COMFORT MODE

After the unit is switched on, it is in
The desired relative humidity (rH) is preset to
50%. The unit chooses the appropriate output le-
vel Low "L" / Medium "M" / High "H", in order to
attain the value of 50% rH as quickly as possible.
In -Mode, the rH can be changed at any time by
using button . If the output level is changed by using
button , the -Mode turns off and the unit is ope-
rated manually.
The heater can be switched on or off without the ap-
pliance leaving mode. mode also remains
active when setting the timer.
To return to mode, tap the symbol once.

CONTROLLING HUMIDITY

The humidity can be set between 30% and 70%. In the
"Co" setting (for "Continuous"), the ultrasonic runs re-
gardless of the measured humidity. This means it does
not switch off until the tank is empty or the appliance is
switched off.
-Mode. 1. Tap the symbol. The current humidity indicator
starts flashing.
2. While the indicator is flashing, tap the
until the desired humidity is set.
The value is applied after a few seconds. The indicator
stops flashing.

REGULATING PERFORMANCE

1. Tap the symbol multiple times until the desired le-
vel appears on the display.
The symbol on the display indicates which of the three
levels (low/medium/high) has been selected:
symbol again
15
en