Nice SMX2 Mode D'emploi page 4

Deleting all transmitters
All the memorised codes can be deleted as follows:
Table "B4" Deleting all transmitters
1. Press the receiver button and hold it down
2. Wait for the Led to light up, then wait for it to switch off
and then wait for it to flash 3 times
3. Release the button exactly during the third flash
N.B.: if the procedure was performed correctly, the Led will flash 5 times after a few moments.
Maintenance
The receivers and transmitters, being electronic components, do not
require any special maintenance. In any case, check the materials
that the device is made of every 6 months for signs of wear, oxida-
tion or presence of foreign bodies.
SM2 - SM4
Disposal
This product is made from various kinds of materials, some of which
can be recycled while others must be scrapped.
Separate as best you can the parts that can or must be recycled
from those that must be disposed of otherwise, such as plastic
parts, electronic boards, batteries, etc.
Sort the various materials and consign them to local authorized recy-
cling and disposal centres
4
Replacing the Remote Control Battery: If your radio control,
after a period of time, seems not to work as well, or not to work at
all, it may simply be that the battery is exhausted (depending on the
type of use, it may last from several months up to one year and
more). In this case you will see that the light confirming the trans-
mission is weak, or does not come on, or comes on only briefly.
Before calling the installation technician try exchanging the battery
with one from another operating transmitter: if the problem is caused
by a low battery, just replace it with another of the same type.
FLO*R-S
FLO*R-SC
FLO*R-M
!
Certain electronic components, as well as batteries,
might contain polluting substances. Do not pollute the
environment.
Enquire about the recycling or disposal systems available
and proceed in compliance with the regulations locally in
force.
Example
RX
x3
3°
RX
x5
Very VR