Cleaning The Appliance - SilverCrest SDBS 2400 A1 Mode D'emploi

NOTE
If the appliance is used regularly, it is advisable to always have a replacement
limescale filter available. This means that you can replace the limescale filter
immediately as soon as the "anti calc" indicator lamp
You can order new limescale filters
section Ordering replacement parts).
1) Switch the appliance off using the On/Off button
down.
2) Remove the power plug from the mains power socket.
3) Remove the iron from the base station and put it to one side.
4) Open the shaft cover
CAUTION
Damage to the appliance!
5) Pull the limescale filter
6) Place the new limescale filter
until it is firmly seated.
7) Close the shaft cover
8) Insert the plug into a mains power socket and switch on the appliance using
the On/Off switch
9) Press the "RESET" button
lamp
You have now completed replacement of the limescale filter

Cleaning the appliance

♦ Clean the iron surfaces and the base station using only a soft, slightly moist
cloth.
♦ Clean the sole of the iron
the iron
♦ Pour the residual water in the water tank
iron down to one side and open the water tank filler cap
♦ The appliance must be completely dry before further use.
■ 38 │ GB │ IE
.
Never pour water into the limescale filter shaft!
upwards out of the limescale filter shaft.
.
.
goes out.
is not scratched.
from our service department (see
in the limescale filter shaft and press it down
for about 3 seconds. The "anti calc" indicator
with a soft moist cloth. Ensure that the sole of
into a basin. To do this, put the
lights up.
and allow it to cool
.
.
SDBS 2400 A1