Worx LANDROID M Guide D'installation page 14

Open the panel cover, press
power button,
then input the default PIN
Press the key and close
the control panel cover: your
Landroid M will now
®
find its way to the charging base.
09:00pm
09:00pm
Wed. 6-8-2012 Watch the Landroid Wed. 6-8-2012
M T W T F
M T W T F S S
7:00am ~ 12:00am
7:00am ~ 12:00am
it returns to the charging
base and modify the
positioning of the boundary
wire if necessary. When the
Landroid M successfully
®
returns to the charging base,
this means the installation has
been successfully completed!
Now your Landroid
start to fully charge.
NOTE: If your Landroid
14
press the Start button to proceed with mowing.
EN
• If your Landroid
is outside its territory,
it will not move and
Warning
the display will indicate
"outside working
area" error. Just move
it inside its territory and
repeat step 2.
NOTE: Please refer to the Programming and Troubleshooting Guide for more information.
2
0000.
09:00pm
M as Wed. 6-8-2012
®
S S
M T W T F S S
7:00am ~ 12:00am
M will
®
M is in the charging base during a time you have programmed it to mow, press STOP then simply
®
M • If your Landroid
®
inside its territory but the
display says "outside
working area" and the
LED is on, it means you
clamped the boundary
wire ends incorrectly.
Just reverse them.
09:00pm
Wed. 6-8-2012
M T W T F S S
7:00am ~ 12:00am
M is • Your Landroid
®
always remain switched
on. If you ever need to
turn it off, then make sure
you place it within its
boundary area before you
switching it back on again.
09:00pm
09:00pm
Wed. 6-8-2012
Wed. 6-8-2012
M T W T F S S
M T W T F S S
7:00am ~ 12:00am
7:00am ~ 12:00am
M should • Should your
®
Landroid M stop
®
operating unexpectedly,
just press its ON/OFF
key to ON, correct the
problems, press Start
button.