Worx LANDROID M Guide D'installation page 13

a
Turn on and test the installation
This is the exciting part where you can turn your Landroid
3
You can now permanently fix the charging base on the ground
by pressing the supplied Base Retention Pegs with the supplied
Hex key.
NOTE: Make sure the IN-wire is running straight
underneath the center of the charging base.
4
b
Connect the power cord to the adaptor and then to the AC
electrical socket, the LED on the charging base will turn on. If
the LED is off, please refer to the Trouble shooting guide.When
connecting, align the notch on the power cord connector (a)
with the groove on the adaptor connector (b).
Make sure to only screw or unscrew the highlighted piece of
the connector.
If the green light does not come on, then check the power
connections.
In case the power cord is within the working area, you may bury
it as needed.
M on for the first time.
®
1
Place your Landroid
working area, a few meters from
the back of the charging base.
M inside the
®
13
EN