Assembly; Operation - Ryobi P317 Manuel D'utilisation

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Driving staples into wood
 Using the included accessory, driving staples to secure
fencing wire and wire screen
WARNING:
Do not use this tool for fastening electrical cables or wire.
It is not designed for electrical cable installation and may
damage the insulation of electric cables, causing electric
shock or a fire hazard.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.

OPERATION

INSTALLING/REMOVING BELT CLIP
See Figure 1, page 9.
The belt clip may be installed on either side of the housing.
 Remove the battery pack.
 Squeeze the prongs together as shown.
 Insert the prongs into the belt clip slot on either side of
the tool.
 When the belt clip is fully inserted into the slot, release
the prongs.
 To remove, squeeze the prongs together and pull the belt
clip out of the slot on the side of the tool.
INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 9.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured in the
product before beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's man-
uals for your battery pack and charger.
WARNING:
Battery tools are always in operating condition. Lock the
switch when not in use or carrying at your side, when in-
stalling or removing the battery pack, and when installing
or removing bits.
LOADING STAPLES
See Figure 3, page 9.
 Remove the battery pack.
 Hold the tool upside down. Squeeze the magazine latch
and slide the magazine open.
 Insert the staples into the channel with the crown side
down and the legs facing upward.
 To close the magazine, push it into the tool until it clicks.
 An indicator window on the side of the tool lets the
operator know when the tool is running low on staples.
6 — English