Features; Assembly; Operation - Ryobi FVD50 Manuel D'utilisation

PRODUCT SPECIFICATIONS
No Load Speed ..............................................................................................................................................200/min. (RPM)
Collet .............................................................................................................................................................................1/4 in.
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Hearing protection may also
be required depending on the type of attachment used
and as prescribed elsewhere in this Operator's Manual.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.

FEATURES

ASSEMBLY

WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.

OPERATION

APPLICATIONS
You may use this product for the purposes listed below:
 Driving screws with screwdriver bits
 Light-duty drilling
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 9.
To install:
 Turn the battery cap counterclockwise to unlock and
remove.
 Insert the battery pack into the product as shown.
 Align the grooves in the cap with the tabs on the end of
the tool.
 Place the cap over the battery pack and push down.
 Turn the battery cap clockwise to lock in place.
NOTE: Do not attempt to use this product if the battery
cap is not securely closed.
To remove:
 Turn the battery cap counterclockwise to unlock and
remove.
 Remove the battery pack from the tool.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
WARNING:
Battery products are always in operating condition.
Therefore, the switch should always be locked when not
in use or carrying at your side.
6 - English