Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
O
PERATION
Total Height in Pixels
The Total Height in Pixels defines the height of the entire connected panel assembly.
1.
Access the
Image Mosaic
2.
Turn the <MENU/ENTER> knob until Total Height Pixels is selected.
3.
Press the <MENU/ENTER> knob.
4.
Turn the <MENU/ENTER> knob clockwise or counter-clockwise to increase or decrease the total
height in pixels, from 128–24576.
5.
Press the <MENU/ENTER> knob.
Load Area Width
The Load Area Width defines the width of the area upon the connected panel assembly to which this VIP
Drive 43Nova will output.
1.
Access the
Image Mosaic
2.
Turn the <MENU/ENTER> knob until Load Area Width is selected.
3.
Press the <MENU/ENTER> knob.
4.
Turn the <MENU/ENTER> knob clockwise or counter-clockwise to increase or decrease the
width, from 128–24576. (This range is determined by the
5.
Press the <MENU/ENTER> knob.
Load Area Height
The Load Area Height defines the height of the area upon the connected panel assembly to which this VIP
Drive 43Nova will output.
1.
Access the
Image Mosaic
2.
Turn the <MENU/ENTER> knob until Load Area Height is selected.
3.
Press the <MENU/ENTER> knob.
4.
Turn the <MENU/ENTER> knob clockwise or counter-clockwise to increase or decrease the
height, from 64–24576. (This range is determined by the
5.
Press the <MENU/ENTER> knob.
Load Area Horizontal Offset
The Load Area Horizontal Offset defines how far to the right on the connected panel assembly this
product's load area begins.
1.
Access the
Image Mosaic
2.
Turn the <MENU/ENTER> knob until Load Area Start X is selected.
3.
Press the <MENU/ENTER> knob.
4.
Turn the <MENU/ENTER> knob clockwise or counter-clockwise to increase or decrease the
offset, from 0–23756. (This range is determined by the
5.
Press the <MENU/ENTER> knob.
The
Load Area Width
only be able to be set as much as the difference between the Load Area Width and
the Total Width in Pixels. For example: If the Total Width in Pixels is 3000, and the
Load Area Width is set to 1600, the offset can be set from 0–1400.
Load Area Vertical Offset
The Load Area Vertical Offset defines how far down on the connected panel assembly this product's load
area begins.
1.
Access the
Image Mosaic
2.
Turn the <MENU/ENTER> knob until Load Area Start Y is selected.
3.
Press the <MENU/ENTER> knob.
4.
Turn the <MENU/ENTER> knob clockwise or counter-clockwise to increase or decrease the
offset, from 0–23756. (This range is determined by the
5.
Press the <MENU/ENTER> knob.
The
Load Area Height
only be able to be set as much as the difference between the Load Area Height and
the Total Height in Pixels. For example: If the Total Height in Pixels is 4000, and the
Load Area Height is set to 1500, the offset can be set from 0–2500.
VIP Drive 43Nova User Manual Rev. 3
menu.
menu.
menu.
menu.
must be less than maximum to use this setting. The offset will
menu.
must be less than maximum to use this setting. The offset will
Total Width in
Pixels)
Total Height in
Pixels)
Load Area
Width)
Load Area
Height)
24
Publicité
Table des Matières
