Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Input Capture Height
The Input Capture Height defines the height in pixels to be captured from the selected video source.
1.
Access the
Input Capture
2.
Turn the <MENU/ENTER> knob until Height (V) is selected.
3.
Press the <MENU/ENTER> knob.
4.
Turn the <MENU/ENTER> knob clockwise or counter-clockwise to increase or decrease the
height, from 48–_ _ _ _. (This range is determined by the
5.
Press the <MENU/ENTER> knob.
Input Capture Horizontal Offset
The Input Capture Horizontal Offset defines how far to the right the video capture will be offset.
1.
Access the
Input Capture
2.
Turn the <MENU/ENTER> knob until Start X is selected.
3.
Press the <MENU/ENTER> knob.
4.
Turn the <MENU/ENTER> knob clockwise or counter-clockwise to increase or decrease the
offset, from 0–_ _ _ _. (This range is determined by the
5.
Press the <MENU/ENTER> knob.
The
Input Capture Width
will only be able to be set as much as the difference between the current Input
Capture Width and the maximum Input Capture Width. For example: If the maximum
Width is 1920, and the current Width is set to 1720, the offset can be set from 0–200.
Input Capture Vertical Offset
The Input Capture Vertical Offset defines how far down the video capture will be offset.
1.
Access the
Input Capture
2.
Turn the <MENU/ENTER> knob until Start Y is selected.
3.
Press the <MENU/ENTER> knob.
4.
Turn the <MENU/ENTER> knob clockwise or counter-clockwise to increase or decrease the
offset, from 0–_ _ _ _. (This range is determined by the
5.
Press the <MENU/ENTER> knob.
The
Input Capture Height
will only be able to be set as much as the difference between the current Input
Capture Height and the maximum Input Capture Height. For example: If the
maximum Height is 1080, and the current Height is set to 880, the offset can be set
from 0–200.
Output Window
The Output Window settings define the dimensions and offset of the video output, as it will appear on the
connected panel assembly. Editing the Output Window settings will shrink or expand the entirety of the
video output, and/or move it around on the connected panel assembly. To access the Output Window
settings:
1.
Access the
Custom Scaling
2.
Turn the <MENU/ENTER> knob until Output Window is selected.
3.
Press the <MENU/ENTER> knob.
Output Window Width
The Output Window Width defines the width in pixels that the video output will be limited to.
1.
Access the
Output Window
2.
Turn the <MENU/ENTER> knob until Width (H) is selected.
3.
Press the <MENU/ENTER> knob.
4.
Turn the <MENU/ENTER> knob clockwise or counter-clockwise to increase or decrease the
width, from 128–_ _ _ _. (This range is determined by the
5.
Press the <MENU/ENTER> knob.
17
menu.
menu.
must be less than maximum to use this setting. The offset
menu.
must be less than maximum to use this setting. The offset
menu.
menu.
Input
Settings)
Input Capture
Width)
Input Capture
Height)
Screen
Settings)
VIP Drive 43Nova User Manual Rev. 3
O
PERATION
Publicité
Table des Matières
