Installing The Led Light; Installing The Filter In The Explorer Line 30 L - Tetra AquaArt Explorer Line 30 Mode D'emploi

 Place the aquarium with the frame at the
bottom in the required position.
 Take out all the parts that are in the tank.
 Clean any impurities out of the tank.
 Never use any hard, pointed or sharp objects
for cleaning purposes.
 Use soft cloths or sponges.
 Add warm tap water at a temperature of
approx. 25 °C to the tank.
 Check the tank for leaks.
 If the aquarium is leaking, empty it and return
the tank to your stockist for a replacement.

Installing the LED light

(Figures A and B)
 Pull out the plugs of all the electrical devices
installed in the aquarium.
 Install the LED light in the position provided for
it (Figure A).
 Do not overtighten the securing screws for
the LED light in order to avoid damaging the
aquarium wall.
Installing the filter in the
Explorer Line 30 l
The AquaArt Explorer Line 30 l Crayfish and the
AquaArt Explorer Line 30 l Goldfish are supplied
with the EasyCrystal Filter 250.
 Pull out the plugs of all the electrical devices
installed in the aquarium.
 Remove the aquarium lid.
 Select a position to install the filter on the
inside of the tank which is not curved.
 Ensure that you keep the filter the required
distances from the base and from equipment
in the aquarium.
The required distances are listed in the attached
instructions for the filter.
English translation of the original German
 Ensure that you satisfy the requirements
relating to the water level set out in the
instructions for the filter.
 Secure the filter vertically on the inside of the
tank as shown in the instructions for the filter.
The cable guides and optional positions for
electrical devices in the aquarium lid are closed
with covers upon delivery. The covers can be
removed by hand or with a pair of pliers.
ATTENTION!
The aquarium lid may be damaged if too
much force is used to remove a cover.
 Score the edges of the cover with a
sharp knife before you remove the
cover.
 Remove the cover carefully.
 If the filter is installed level with the aquarium
lid, carefully remove the cover from the
corresponding optional position in the
aquarium lid (Figures B and C).
 If the filter is installed below the aquarium lid,
carefully remove the cover from a cable guide
for the mains cable (Figures B and C).
 If the cable guides or optional positions have
sharp edges, smooth them with a small file.
 Route the power cable upwards and out of the
aquarium.
 Follow the attached instructions for the filter
to complete the remainder of the installation
work.
Installing the filter box and
heating element in the Explorer
Line 60 l
The AquaArt Explorer Line 60 l is supplied with
the EasyCrystal FilterBox 300. This contains the
filter. In addition it houses the supplied heating
element.
instructions
7