Intended Use; Unpacking And Installation - Tetra AquaArt Explorer Line 30 Mode D'emploi

English translation of the original German
instructions
Warnings
CAUTION
Notes containing the word CAUTION warn
of a situation which leads to slight or
moderate injuries.
Information
ATTENTION!
These notes warn of a situation which
leads to material damage or environmental
pollution.

Intended use

The aquarium is designed exclusively for
keeping ornamental fish and invertebrates such
as crabs or shrimps. The maximum water
temperature of 35 °C must not be exceeded. The
aquarium is designed for use only in enclosed
rooms. The LED light may only be mounted and
operated on this aquarium.
Proper use also includes heeding all the
information in these instructions and in all
attached instructions and complying with the
safety information.
The use of the product for any other purpose is
regarded as improper and may result in damage
to property or personal injury and shall render
the warranty null and void.
In particular, the aquarium must not be used in
the following cases:
• If you carry out unauthorised modifications or
repair work.
• If you use the aquarium outside enclosed
rooms.
Tetra GmbH will not accept liability for loss or
damage incurred by improper use.
6

Unpacking and installation

There must be properly installed and earthed
sockets (230 V ~ 50 Hz) near the installation site
of the aquarium for the electrical devices in it.
 Pull out the plugs of all the electrical devices
installed in the aquarium.
CAUTION
Shards of glass can cause cuts.
 Ensure that you do not break the tank.
 Do not touch the shards of glass if the
tank breaks.
 Wear gloves.
 Remove all shards of glass carefully.
ATTENTION!
The aquarium lid may be damaged and the
glass broken if you unpack it incorrectly.
 Lift the aquarium by the frame only.
 Always lift and transport the aquarium
with another person.
 Open the packaging.
 Carefully lift the aquarium out of the
packaging.
ATTENTION!
The aquarium may be damaged if you
select an unsuitable position for it.
 Ensure that the position is flat, horizontal
and waterproof.
 Ensure that the position for it is capable
of taking the weight of the unit.
The load capacity of the installation position
must be high enough to support three times the
filled weight of the aquarium. Information about
the gross weight is available in the section
entitled Technical data starting on page 9.