Initial Use - Tetra Tetronic LED ProLine 380 Mode D'emploi

Attaching the LED light using screws
The multi adapters are required for this attachment option.
Procedure:
Fig. D
1. Place the multi adapters over the bayonet connectors on the
extension arms.
2. Rotate the multi adapters by 90° until they click into place.
– The multi adapters must be positioned above the lamp.
3. Push the extension arms into the openings at both ends of
the LED light.
– The teeth on the extension arms must point towards the
lamp.
4. Adjust the extension arms to the required length and secure
the multi adapters with three screws each.
– The arms must not be extended by more than 12.5 cm
each.
Tetronic LED ProLine Arms
The Tetronic LED ProLine Arms bracket is optionally available for
aquariums or terrariums without a lid.
Procedure:
Fig. F – H

INITIAL USE

The switch on the connection cable enables you to switch the
LED light between day and night mode as well as to switch it off
entirely.
Procedure:
Fig. E
1. Connect the two sections of the connection cable.
2. Plug the power supply into the socket.
– The lowest point of the connection cable must be below
the socket to prevent any water that drips down from
entering the socket.
3. Press the switch.
– 0 = light off
– I = day mode
– II = night mode
UK
13