Installing The Monitor - Dometic WAECO PerfectView M7LS Instructions De Montage Et De Service

_M7LS.book Seite 32 Freitag, 14. Oktober 2011 5:32 17
Mounting the monitor
To make and test the electrical connection, the following tools are required:
Diode test lamp (1) or voltmeter (2)
Insulating tape (10)
Heat shrinking sleeve
Hot air blower (11)
Crimping tool (12)
Soldering iron (optional) (13)
Solder (optional) (14)
Cable bushing sleeves (optional)
Depending on the individual installation requirements you may require bolts, nuts, wash-
ers, self-tapping screws and cable binders other than those including in the scope of de-
livery.
7.2

Installing the monitor

CAUTION! Risk of injury!
!
Select the location of the monitor so that it cannot injure the passengers in the
vehicle under any circumstances (e. g. sudden braking, road traffic accidents).
Observe the following installation instructions:
Select an installation location that provides an unobstructed view of the monitor
(fig. 0, page 6 and fig. a, page 6).
Never install the monitor in area where your head could impact it or in the air bag de-
ployment path. This could cause injury if the airbag opens.
The monitor must not impair your vision when driving (fig. b, page 7).
The installation location should be flat.
Check that there is sufficient space underneath the installation location to attach the
washers and nuts.
Check beforehand that there is sufficient space on the other side for the drill head to
come out.
Bear in mind the weight of the monitor. Provide reinforcement if necessary (larger
washers or plates).
Ensure that you can lay the connection cable set to the monitor.
32
PerfectView M7LS
EN