Mounting The Lcd Monitor; Installing The Monitor - Dometic WAECO PerfectView M5L Instructions De Montage Et De Service

All manuals and user guides at all-guides.com
_M5L_M7L_M7LX.book Seite 29 Donnerstag, 14. Januar 2010 3:03 15
PerfectView M5L, M7L, M7LX
7

Mounting the LCD monitor

7.1 Tools required (fig. 1, page 2)
For installation and assembly you will require the following tools:
Measuring ruler (4)
Centre punch (5)
Hammer (6)
Drill bit set (7)
Drill (8)
Screwdriver (9)
To make and test the electrical connection, the following tools are required:
Diode test lamp (1) or voltmeter (2)
Insulating tape (10)
Heat shrinking sleeve
Hot air blower (11)
Crimping tool (12)
Soldering iron, if required (13)
Solder, if required (14)
Cable bushing sleeves, if necessary
To fasten the cables, you may require additional cable binders.
7.2

Installing the monitor

CAUTION! Risk of injury!
!
Select the location of the monitor so that it cannot injure anybody in
the vehicle under any circumstances (e.g. sudden braking, road traffic
accidents).
Observe the following installation instructions:
Select an installation location that provides an unobstructed view of the monitor
(fig. 6, page 3 and fig. 7, page 3).
Never install the monitor in areas where your head may impact or in the area that
would be filled by an expanding airbag. This could cause injury if the airbag opens.
The monitor may not impair your vision when driving (fig. 8, page 4).
The installation location should be flat.
Check that there is sufficient room underneath the installation location to attach
the washers and nuts.
Mounting the LCD monitor
29