Using The Lcd-Monitor - Dometic PERFECTVIEW M7LS Instructions De Montage Et De Service

M7LS
➤ Connect the mini DIN socket (11) of the system cable (10) of to the mini DIN plug (12) of the
camera cable.
➤ Connect the green cable (8) to the positive cable of the reversing light.
I
NOTE
If a voltage is present on the green cable, the monitor is switched on automatically and
the camera is activated.
8

Using the LCD-monitor

Switching on the monitor (fig. d, page 8)
8.1
I
NOTE
The monitor is switched on automatically, if you shift into reverse gear. The image is
transmitted by the camera.
➤ If the monitor is switched off, press the "Power" main switch (6), to switch the monitor on.
✓ The picture appears.
✓ The brightness of the display is automatically adapted to the ambient light.
Switching off the monitor (fig. d, page 8)
8.2
➤ Press the main switch "Power" (6), to switch off the monitor.
✓ The picture disappears.
Setting the volume (fig. d, page 8)
8.3
You can set the volume to amplify or mute the the noises transmitted by the camera.
➤ Press the "–" button (3) to reduce the volume.
➤ Press the "+" button (5) to increase the volume.
EN
Using the LCD-monitor
21